(spegnere, accendere, ecectera)
Provate con il vostro samsung
Un ringraziamento a distanza all'autore della guida
dawgpound6985 del sito HowardForum
1. FIRST and foremost, make sure your battery is fully charged! Remove the SIM card
AND the battery from the phone. Turn off any power savings on your computer such as
screensavers, standby, hibernate so that it won't interfere with the flashing.
2. Extract/Place ALL FOUR files into ONE folder any where on your computer.
3. Download OneNAND. This will be the software used to flash the firmware.
4. Open up your Device Manager on your computer (Right Click on My Computer -->
Properties --> Hardware Tab --> Device Manager). Scroll Down to Ports (COM & LPT)
and click on the "+" sign). Take note of the USB Datacable VCP (COM #) where # is
the port # you will enter in OneNAND.
5. Open OneNAND and check "Don't Auto NAND Format" <-- VERY IMPORTANT!!! Change the
Serial Port to the port # found in step 4 and change the baud rate (number next to
com port which is the speed of data. Higher = faster) to the highest you can put it.
In my case its COM port 4 and 921600 and may be different depending on the
computers.
6. Connect the cable to the phone first AND THEN put in the battery and hit "Start"
7. Turn on the phone when you see the **(Power ON the PHONE!) message. Wait for
program to show **Now you can do DOWNLOAD! ** message.
8. Once that message appears you're half way done. Click on "BIN+TFS" on mid-right
of OneNAND (See Purple Arrow).
9. Click on BIN and point it to where you placed the G600XEGL1.cla file. Hit CRC
Checksum (See Red Arrow).
10. Click on TFS and point it to where you placed the G600XEGL1.tfs file. Hit CRC
Checksum (See Yellow Arrow).
11. Finally, hit "Download." Sit back, relax, do the dishes, don't touch your
computer so that it doesn't mess anything during the flash. It'll take a while.
** Start BINARY downloading... message will appear and the phone flashing will begin
Next the ** Start Downloading TFS file ** message will appear. This part takes the
longest by the way so don't be surprised its slower than the binary.
Download Completed! Hit "OK" but DON'T EXIT the program just yet!!!!!
You will click on STOP and then you may exit the program.
As you can see from the screenshot it took 47 mins and 56 secs to flash the firmware
on my phone.
Unplug the USB Cable. Place your SIM Card and turn on the phone. If you got this
far, congratulations!!! You just flashed your phone with a new firmware!
Cià
Paolo